Harman Kardon FL8300 - Page 26

harman/kardon TECH TIPS
Troubleshooting tips and solutions to common service problems
For models: FL8300 TIP# HKTT2003-02
Problem: "Carousel not stopping in the correct position, so disc can be clamped correctly".
Check:
1) 6-conductor Ribbon cable connection to sensor board - check cable; clean, re-seat at both
ends.
2) There is a post/standoff underneath the single center screw in the center of the carousel (under
the plastic 1,2,3,4,5 cap). If that post/standoff is too long, it can cause the symptom. If the part
is higher than the surface of the carousel in that area, the part needs to be shaved down so it's
shorter.
3) Defective Roulette sensor (part# 2408001111) or Disc sensor (part# 2408210001).