Harman Kardon HD7725 - Power Cord Replacement

{5] CD PLAYER MECHANICAL ASSEMBLY (104) REMOVAL
1.
Remove the Cabinet Top (124), referring to the previous
step [1].
Disconnect the connector with lead wires (LCN113, LCN114,
LCN115 and LCN117) from connectors (CN113, CN114,
CN115 and CN117) on the Main P. C. Board (PCB-1).
Remove 3 screws (F) and then remove the CD Player
Mechanical Assembly (104) backward.
DISASSEMBLING THE CD PLAYER
MECHANICAL ASSEMBLY
[6] DISC TRAY (1) REMOVAL
1.
Remove the Cabinet Top (124), referring to the previous
step [1].
Connect the Power cord and turn on the power by pressing
the Power switch.
Open the Disc Tray (1) by pressing the Open/Close button.
With the Disc Tray (1) opened as it is, pull out the power plug.
Push the Disc Tray (1) by hand to slide it in once.
6. Loosen the 2 screws (H) and then slide out the Disc Tray
(16) by hand.
[7] OPTICAL PICK-UP (57) REMOVAL
1.
Remove the CD Player Mechanical Assembly (104), referring
to the previous step [5].
Remove 4 screws (|) and then remove the Disc Motor,
Pick-up and Slide Motor Assembly (13) from the CD Player
Mechanical Assembly (104).
Remove gear (58) by gently pressing at its base, to release it
and pull it out of the Disc Motor, Pick-up and Slide Motor
Assembly (13).
Slide the sled shaft (51) towards the disc motor and at the
same time open sled shaft stop (J). Gently slide the sled
shaft (51) out of the Disc Motor, Pick-up and Slide Motor
Assembly (13).
Remove the Optical Pick-Up (57) from the Disc Motor,
Pick-up and Slide Motor Assembly (13).
[8] SLIDE MOTOR (60) REMOVAL
1;
Unsolder the terminals of the Disc and Slide Motors, then
remove the Motor P. C. Board (61).
2. Remove 2 screws (k) and then remove the Slide Motor (60).
POWER CORD REPLACEMENT (FOR SERVICE ENGINEERS OTHER THAN NORTH AMERICA)
in
order
to
prevent
fire
or
shock
hazard
when
replacing
the
power
cord,
follow
the
procedure
below
to
replace
the
part
with
the
standard supply parts.
Pt
POWER CORD
Yof
Pinch the power cord with L- ye
the holder and fit the
holder into the hole on
the cabinet
100mm
a ed
—an f
CABINET BACK
HOLDER