HK3700/HK3770
Quick Start Guide
Place the Stereo Receiver
Connections
• Place the Stereo receiver on a firm and level surface. Be certain that the surface and any mounting hardware can support the
Stereo receiver’s weight.
• Provide proper space above, below, behind and to the sides of the Stereo receiver for ventilation. Maintain a clearance of at least 12"
(30cm) on each side of, above and behind the unit.
• If you install the Stereo receiver in a cabinet or other enclosed area, provide cooling air within the cabinet. Under some circumstances,
a fan may be required.
• Do not obstruct the ventilation slots on the top of the Stereo receiver or place objects directly over them.
• Do not place the Stereo receiver directly on a carpeted surface.
• Do not place the Stereo receiver in moist or humid locations, in extremely hot or cold locations, in areas near heaters or heat registers,
or in direct sunlight.
CAUTION: Before making any connections to the Stereo receiver, ensure that the Stereo receiver’s AC cord is unplugged from the
Stereo receiver and the AC outlet. Making connections with the Stereo receiver plugged in and turned on could damage the speakers.
HK 3700
1
2
1) FM and AM radio antenna
connectors
2) RJ45 Network connector
3) Remote IR and subwoofer
trigger connectors
4) AC input connector
5) Phono input
6) Analog audio inputs
7) Rec Out output
8) Subwoofer output
9) Speaker 1 & 2 outputs
1
5 6 7 8
2 3 4
9
RIGHT LEFT
RIGHT LEFT
REC OUT PREOUT
NOTE: For complete information about using all of your HK3700 and HK3770, download the HK3700 and HK3770 Owner’s Manual from
www.harmankardon.com.
To Next Page
General
Weight and Dimensions
