Harman Kardon HK6300 - Controls and Functions; Power Switch and Indicator; Headphone Jack Usage; Speaker Selector Operation

has r an/kardon HK6500
POWER HEADPHONES SPEAKERS BASS TREBLE
le
OO
@
BALANCE TAPE MONITOR FUNCTION
Tuner
MD
at)
VOLUME
a Vo
Tape 1 SOE Fong co Phono
@ POWER SWITCH (POWER)
Pressing this switch will turn on the power and the POWER
indicator lights up. Press the switch again to turn the power
off.
@ POWER INDICATOR (POWER)
When the POWER switch is pressed, this indicator lights up
in green.
® HEADPHONE JACK (HEADPHONES)
Stereo headphones with a standard 1/4 inch plug can be
connected to this jack. When the SPEAKERS selector is in the
Off position, sound can still be obtained via the headphone
jack.
@ SPEAKER SELECTOR (SPEAKERS)
This selector is used to select the desired speaker system(s).
Off +: Select this position to listen to sound via the head-
phone with no sound from the speaker system(s).
1 : Select this position to actuate the speaker system
connected to the SPEAKER SYSTEM 1 terminal.
2 : Select this position to actuate the speaker system
connected to the SPEAKER SYSTEM 2 terminal.
1+ 2: Select this position to actuate simultaneously the two
speaker systems connected to the SPEAKER SYS-
TEM 1 and 2 terminals respectively.
Integratecg
Amplifie
® BASS CONTROL KNOB (BASS)
This knob controls the low frequency sound level. Turn it
clockwise to boost or counterclockwise to reduce the low
frequency sound level.
@ TREBLE CONTROL KNOB (TREBLE)
This knob controls the high frequency sound level. Turn it
clockwise to boost or counterclockwise to reduce the high
frequency sound level.
@ BALANCE CONTROL KNOB (BALANCE)
This knob is used to balance the left and the right channels.
Usually, it is set at the center. Turn it to the left or right to
balance the sound if it seems unbalanced from the speakers
or the headphones.
@ PHASE CORRECT LOUDNESS SWITCH (Phase
Correct Loudness)
This switch activates a unique low frequency equalization
circuit that provwvides full, natural sound from small speakers
that are normally deficient in the bass region. It can also be
used in place of conventional loudness compensation.