Harman Kardon HK695 - User Manual

Questions and Answers

R
Roger RichmondAug 13, 2025
What to do if Harman Kardon HK695 volume is low?
- J
  jacksonrachaelAug 13, 2025
  If the volume on your Harman Kardon Stereo System is too low, first increase the volume level on the control/right speaker. Also, check the volume level and mute setting in Windows Volume Control to ensure they are properly adjusted.
M
Matthew ToddAug 16, 2025
What causes a Harman Kardon HK695 Stereo System subwoofer to hum?
- R
  richmondamyAug 16, 2025
  A loud hum or buzzing noise from your Harman Kardon Stereo System's subwoofer could be due to input cables not being plugged in properly. Check the input cable connection to ensure it is secure.
A
alopezAug 20, 2025
How to properly connect the control/right satellite speaker on Harman Kardon HK695?
- D
  devon94Aug 20, 2025
  To ensure the control/right satellite speaker is properly connected to your Harman Kardon Stereo System, make sure the control speaker connector is fully pushed in. Remove the control/right speaker connector from the subwoofer, then reconnect it, ensuring it is securely and properly inserted.
J
Jessica SanchezAug 25, 2025
Why does my Harman Kardon HK695 Stereo System have static?
- J
  Jim OwensAug 25, 2025
  Static, crackling, or hissing sounds in your Harman Kardon Stereo System can stem from several factors. The monitor may be causing interference, so try turning it off or moving the speaker cables further away. Also, the speaker might be overdriven by an amplified audio source; ensure it's connected to the correct receptacle and that all signal cables are snugly inserted. Check the volume level on the sound card via Windows Volume Control, as it may be too high. To isolate the problem, test the speakers with another audio source like a portable CD player. If the issue persists, set the treble, bass, and surround knobs on the subwoofer to their center positions.
J
Jennifer AveryAug 27, 2025
How to fix Harman Kardon HK695 Stereo System when it has no power?
- S
  Susan WellsAug 28, 2025
  If your Harman Kardon Stereo System isn't powering on, first, ensure the wall outlet or power strip has power and that all related switches are turned on. Toggle the power switch on the system itself. If it still doesn't work, replace the fuse located on the back of the subwoofer between the power cord connector and the power switch. Use a screwdriver to turn a quarter turn in the direction indicated by the arrow. A spare fuse was supplied with the product, attached to the AC cord. Refer to the specification section for fuse details.
M
Michael HansenAug 31, 2025
How to reduce excessive bass or treble on Harman Kardon HK695?
- M
  Michelle ThorntonAug 31, 2025
  If your Harman Kardon Stereo System has too much bass or treble, the bass/treble level may be set too high. Try turning the bass/treble down or returning their settings to the nominal position.
D
Daniel WallSep 3, 2025
Why does my Harman Kardon Stereo System pick up radio interference?
- T
  tfoxSep 4, 2025
  If your Harman Kardon Stereo System is experiencing radio frequency interference, the input cable may be picking up interference. Try wrapping up any excess input cable to make it as short as possible. You can also purchase a ferrite clamp and attach it over the input cable to reduce interference. These clamps are available at most local electronics stores.
A
Allison WrightSep 7, 2025
How to stop Harman Kardon HK695 hum with stereo soundcard?
- M
  Matthew StewartSep 8, 2025
  If your Harman Kardon Stereo System emits a loud hum or buzzing noise when used with a stereo soundcard, it may be because the redundant rear (black) audio connector is not protected by the rubber cover and is touching the computer system. Replace the rubber cover or otherwise insulate the rear audio connector to prevent it from contacting any metallic surfaces.