4
HKTS 210 SUB/HKTS 200 SUB Connecting the Subwoofer
Connecting the Subwoofer
Connecting the Subwoofer to a Receiver or Preamp/Processor
With a Dedicated Subwoofer Output
(HKTS 210 SUB only):
Set Input Mode
Switch to “LFE”
LFE/Trigger Cable
(supplied)
Use this installation method for receivers and preamps/processors that have a dedicated
subwoofer output with low-pass filtering (also called bass management). If the dedicated
subwoofer output does not have low-pass filtering, follow the instructions in Connecting
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs on this page.
Use the LFE (purple) connector of the supplied combination LFE and trigger cable to
connect the subwoofer’s Line-Level LFE In connector to the dedicated subwoofer output
(or LFE output) of your audio/video receiver or preamp/processor. HKTS 210 SUB only:
Set the Input Mode switch in the “LFE” position.
Configure your receiver or preamp/processor’s setup menu for “Subwoofer On.” After
you have made and verified all connections, plug the subwoofer’s AC Power Cord into
an active AC outlet.
Connecting the Subwoofer to a Receiver or Preamp/Processor
With Line Outputs
L R
LINE-LEVEL
OUTPUTS
(HKTS 210 SUB only):
Set Input Mode
Switch to “Normal”
Stereo RCA Cable
(not supplied)
Use this installation method for receivers and preamp/processors that do not have a
dedicated subwoofer output but do have preamp-level (volume-controlled) line outputs.
If the receiver or preamp/processor has a dedicated subwoofer output with low-pass
filtering, see Connecting the Subwoofer to a Receiver or Preamp/Processor With a
Dedicated Subwoofer Output on this page.
Connect one end of a stereo RCA cable (not supplied) to the receiver’s or preamp’s line
outputs and the other end to the subwoofer’s Line-Level L/R In connectors. HKTS 210
SUB only: Set the Input Mode switch in the “Normal” position.
After you have made and verified all connections, plug the subwoofer’s AC Power Cord
into an active AC outlet.
To Next Page
Loading...
