30 REMOTE CONTROL
Remote Control
Example: To program the Macro 1
K
button
so that it turns on the HS 350 and your TV,
follow these steps:
• Press the Macro 1 button
K
and Mute
A
buttons at the same time and then release
them.
• Note that the Program Indicator will flash
amber.
• Press the TV Selector
0
.
• Press the Mute
A
button to store the HS’s
power on command.
• Press the Screen Power On button
button to store the TV Power On Command.
• Press the
MNKL
button
9
to complete
the process and store the macro sequence.
After following these steps, each time you press
the Macro 1 button
K
, the remote will send
all Power On commands.
Erasing Macro Commands
To remove the commands that have been
programmed into one of the Macro buttons,
follow these steps:
1. Press the Mute button
A
and the Macro
button
K
that contains the commands you
wish to erase.
2. Note that the Program Indicator
will
flash amber, and the red LED under the Input
Selector
0
last used will turn on.
3. Within ten seconds, press the Mute button
A
.
4. The red LED under the Selector will go out,
and the Program Indicator
will turn
green and flash three times before it goes out.
5. When the Program Indicator
goes out,
the Macro has been erased.
To Next Page
Loading...
