3
ENGLISH
INSTALLATION
INSTALLING
With only a single cable connection, The Bridge II is
easy to connect to your Harman Kardon product.
Step One: Turn off the Harman Kardon The Bridge-
or The Bridge II-ready product, using its master power
switch.
Step Two:
-Ready Products – Holding the
cable with the wider part of the connector at the
bottom, gently squeeze the tabs on each side as
you insert it into the connector on the rear panel of
THE(ARMAN+ARDONPRODUCT3EE&IGURE
&IGUREn4HE"RIDGE))CONNECTORON4HE"RIDGE))READY
Harman Kardon products
-Ready Products – A different con-
nector was used on The Bridge-ready Harman Kardon
PRODUCTSANDTHE(+ASSHOWNIN&IGURE$O
not plug The Bridge II directly into the DMP/The Bridge
CONNECTORONTHEREARPANELOFTHESEPRODUCTS&IRST
connect the included adapter to The Bridge II cable,
then plug the adapter into the product.
&IGUREn4HE$-04HE"RIDGECONNECTORON4HE"RIDGEREADY
Harman Kardon products
Step Three: Place the black insert in The Bridge II,
MAKINGSURETOPUSHITALLTHEWAYDOWN3EE&IGURE
NOTE: Do not place an iPod in The Bridge II unless
both the black insert and a dock adapter are installed.
/THERWISETHEI0ODWILLNOTCONNECTPROPERLYAND
both it and the Bridge II may sustain damage that
is not covered by the warranty.
Step Five
Step Four
Step Three
Step Four:,OCATETHEDOCKADAPTERTHATWAS
included with your iPod, or select one of the included
clear dock adapters by referring to Table 1. If your iPod
is an older model that does not appear in Table 1 and
that did not include an adapter, contact Apple Inc. to
purchase one.
Place the adapter in The Bridge II insert, as shown
IN&IGURE
Step Five:2EMOVETHEI0ODFROMANYCASEAND
DOCKITIN4HE"RIDGE))ASSHOWNIN&IGURE
The Bridge II Insert iPod Model
.!./ iPod nano, 1st and 2nd generation
'6)$%/'" I0ODTHGENERATION'"'"ANDI0ODCLASSIC1'"
'6)$%/'" I0ODTHGENERATION'"ANDI0ODCLASSIC'"
13 iPod nano, 3rd generation
12, 1 I0ODTOUCHnINSTALLLARGEBUMPER
Table 1 – Select the Correct The Bridge II Insert
&IGUREn
Docking an iPod
in The Bridge II
To Next Page
Loading...
