Harman Kardon THE BRIDGE II - TROUBLESHOOTING; Common Issues and Solutions; Product Specifications

6
TROUBLESHOOTING
SPECIFICATIONS:
$IMENSIONS(X7X$vXvXvMMXMMMM
7EIGHTLBKG
© 2008 Harman International Industries, Incorporated. All rights reserved.
(ARMAN+ARDONISATRADEMARKOF(ARMAN)NTERNATIONAL)NDUSTRIES)NCORPORATEDREGISTEREDINTHE5NITED3TATES
ANDOROTHERCOUNTRIES$ESIGNEDTO%NTERTAIN4HE"RIDGELOGOAND4HE"RIDGE))LOGOARETRADEMARKSOF(ARMAN)NTERNATIONAL)NDUSTRIES)NCORPORATED
I0ODISATRADEMARKOF!PPLE)NCREGISTEREDINTHE53ANDOTHERCOUNTRIESI0ODNOTINCLUDEDh-ADEFORI0ODvMEANSTHATANELECTRONICACCESSORYHAS
been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. Apple is not responsible
for the operation of this device or its compliance with safety and regulatory standards.
&EATURESSPECIFICATIONSANDAPPEARANCEARESUBJECTTOCHANGEWITHOUTNOTICE
SYMPTOM SOLUTION
The iPod does not play or respond to
commands from the receiver’s remote.
s-AKESURETHAT4HE"RIDGE))ISPROPERLYCONNECTED
to a compatible Harman Kardon receiver.
sMake sure that DMP or The Bridge is selected as
the input on the receiver.
4HE,%$UNDER4HE"RIDGE))GOESOUT
WHENTHERECEIVERISINTHE3TANDBYMODE
sCheck the menu setting on your receiver to make sure
THATTHEOPTIONTOCHARGEI0ODWHILEIN3TANDBYMODEIS
turned on, if available.
s-AKECERTAINTHATTHERECEIVERISINTHE3TANDBYMODE
by looking for the amber standby light. The iPod will not
CHARGEWHENTHE-ASTER0OWER3WITCHISOFF
The display and controls on the iPod
do not operate in iPod mode.
sThis is normal and does not indicate a problem
with the iPod, The Bridge II or your receiver.
TROUBLESHOOTING GUIDE