Installing Wall-Mount (MSD) Panels
28
Modero S Series G4 Touch Panels - Installation & Hardware Reference Manual
FIG. 23 shows the Backbox for the MSD-431-L:
NOTE: For typical mounting surfaces, such as drywall, use the locking tabs as the primary method for securing the Backbox to the
surface. For thin walls or solid surfaces, use mounting screws (not included).
STEP 1: Install the Plastic Backbox
Installation Templates (Included)
Each S-Series panel comes with an Installation Template that makes it easy to position the panel for mounting and establish the
size of the cutout hole required for each panel type. Use the included Installation Template to determine the placement of the
Backbox in the mounting surface. The outside edges of the template are the same dimensions as the touch panel, which allows you
to troubleshoot possible conflicts with wall edges, doors, and other potential obstacles. The S Series installation templates are
shown in FIG. 24:
NOTE: Prepare the area by removing any screws or nails from the drywall before beginning the cutout process.
MSD-1001-L - Template, Backbox, 10.1" Touch Panel, Modero S Series (68-2265-03 - see FIG. 25 on page 29)
MSD-701-L - Template, Backbox, 7.0" Touch Panel, Modero S Series (68-2265-02 - see FIG. 26 on page 29)
MSD-431-L - Template, Backbox, 4.3" Touch Panel, Modero S Series (68-2265-01 - see FIG. 27 on page 30)
The templates are marked to ensure that the touch panel and Backbox are properly aligned.
FIG. 23
4" MODERO S Backbox (Front View)
FIG. 24 S Series Installation Templates
Locking Tab (X2)
Locking Tab screw (x2)
Mounting holes (X4) for use with
Use these mounting holes to install
mounting screws (not included)
the Backbox into thin walls (less
than 0.5” thick) or solid surfaces
Mounting holes (X2) for installing the Backbox into a Rough-In Box (screws not included)
To Next Page
Loading...
Need help?
General
