1919
www.jbl.com
English
7. PLAY
7.1 Power-on/Auto standby/Auto wakeup
HELLO
7.1.1 Switch on
• To switch on, press any button on the soundbar, or on the
remote control.
J “HELLO” is displayed.
J The subwoofer is reconnected to the soundbar
automatically. Connected: turns solid white.
J The detachable speakers are reconnected to the
soundbar automatically. Connected: The status
indicator turns solid white ( )
7.1.2 Auto standby
If the soundbar is inactive for more than 10 minutes, it will switch
to standby mode automatically. “STDBY” is displayed.
J The subwoofer also goes to standby, and turns solid
amber.
J The detachable speakers switch to standby, and the status
indicator turns off for wireless connection status.
J Next time you switch on the soundbar, it returns to the last
selected source.
NOTES:
– On the detachable speakers, press and hold for more than 3 seconds
to switch off. To reconnect to the soundbar, press again and then,
if necessary, press to switch to the soundbar mode.
7.1.3 Auto wakeup
In standby mode, the soundbar will wake up automatically when
• the soundbar is connected to your TV through the HDMI ARC
connection and your TV is switched on;
• the soundbar is connected to your TV through the HDMI
ARC connection and through the HDMI connection, is also
connected to your digital device such as a set-top box, DVD/
Blu-ray player or game console, and your digital device is
switched on;
• the soundbar is connected to your home network and audio is
streamed to the soundbar through the music streaming services
over JBL One app, Chromecast built-in, AirPlay or Alexa Cast.
7.2 Play from the TV source
With the soundbar connected, you can enjoy TV audio from the
soundbar speakers.
OPTICAL
HDMI eARC/
HDMI ARC
TV
1. Make sure that your TV is set to support external speakers
and the built-in TV speakers are muted. Refer to the owner’s
manual of your TV for more information.
2. Make sure that the soundbar has been properly connected
to your TV (See “5.1 Connection with your TV and digital
devices”).
3. To select the TV source, press on the soundbar or TV on
the remote control.
J “TV”: The TV source is selected.
• In the factory settings, the TV source is selected by
default.
NOTES:
– If the soundbar is connected to your TV through both an HDMI cable
and an optical cable, the HDMI cable source is selected for the TV
connection.
7.2.1 TV remote control setup
To use your TV remote control for both your TV and the soundbar,
check that your TV supports HDMI-CEC. If your TV does not
support HDMI-CEC, follow the steps under “TV remote control
IR learning”.
HDMI-CEC
If your TV supports HDMI-CEC, enable the functions as instructed
in your TV user manual. You can control the volume +/-, mute/
unmute, and power on/standby functions on your soundbar
through the TV remote control.
TV remote control IR learning
Through IR learning, your Infra-red TV remote control can learn
some commands of the soundbar.
1. On the soundbar, press and hold and until
“LEARNING” is displayed.
J You enter the TV remote control learning mode.
To Next Page
Loading...
