Harman JBL BAR 2.1 DEEP BASS - Page 33

IMPORTANT SAFm INSTRUCTIONS
For all products:
1. Rad these lnstlUClions.
2. Keep these lnstruttlons.
3. Heed all warnings.
4. Follow au instruttions.
5. Do not use this apparatus ntar water.
6. Clean only with• lky doth.
7. Do not block any ventllitian openings. Install this~ In acCllldanc! with the
manufactum's Instructions.
8. Do not Install this app,ratus nNr q hnt SOUlt!S sudl as radiators, hNt reglste,s,
StlM!s "'other appllalaS (lndudlng implltiets) that produce hat
9. Do notdeffitthe smty purpose of the polarized or gftllllldlng-type plug. A
polwed plug bas two blades with°"' wider thin dlt othet A graunding-type
plug bas two blades and a tbidgraundlng prong. Thewtde blide or the dlid prong
Is provided fer ,-saret,. lfthe pnwlded plug does not fit Into,- outlt1, consult
in electrldan for replamnent of the~ outlft.
10. Protect the power conl fnlm being walfd an or pindled, partkulilty at plugs,
COIMMIIC! receptades and the point wllele theyecltflom the appiratus.
11. list only attidlment!lacmsorles specified bf the manufactlm.
12. Use onlJ with the cart, SW!d, ~ brat or table specified bJ
the manufactuier or sold wltll the apparatus. When a cart Is used.
use CJUllon when mewing the art/apparatus comblnltian to
Mid Injury from tip-Mr.
13. Unplug this apparatus during llghlnlng storms or wllen ll1Used far long periods
oftlmt.
14. Refer all servicing to qaalffled servk! penanntl. Servldng Is~ when the
appa,IIUShas beendaNgedlnifl/W'f, sudlaswhen the power~ COid or
plug Is damaged.llqaldhas been !pledoral,jectsltaveflllen lnlDtlleijlpal'atus,
or the .,at1IS has been erpostd ID rain or mol5IIR. does not ope{ate llOffllllly
arhasbeendlopped.
15. Do ROtsposethls appanlus todlfpplng or splesllill and ensutethat no objKts
Med with liquids, such as vases. are pllC!dan the apparatUs.
16. To dlsalnAed this appmtus hnt the IC. mains lllffllllettl,, dlsGlnnect the power-
-, coni plugframthe IC.lfflPlade.
17. The mains plug of the power-supply conl shall remain rNCllty operable.
ll Do not npose bltttri'5 to acess1ve htitsudl as sunshine, rw or the lie.
19. This apparatus Is intended to be used only with the power supply and/or
charging cable provided bJ the manufactuier.
CAUTION
RISK OF ELECTRIC SHOCK . DO NOT OPEN .
A
THE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL. WITHIN AN
EQUILATERAL TRIANGLE. IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED'DANGEROUS VOLTAGE'WITHIN THE
PRODUCT'S ENCLOSURETHAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS
INTENDED TO ALERTTHE USER TO THE PRESENCE OF IMPORTANT
OPERATING AND MAINTENANCE ( SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING TliE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, 00 NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
CAUTION FCC AND IC STAT EMENT FOR USERS (USA AND
CANADA ONLY)
This device complies with part 15 of the FCC Rules. Operation Is subJKt to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference rece1wd, lnduding Interference that may cause undesired operation
CAN ICES - 3(8)/NMB-3{8)
FCC SDOC SUPPLIER'S DECLARATION OF CONFORMITY
HARMAN lnlemational hereby declares that this equipment is in compliance with the FCC
Part 15 Subpart B.
The declaration of conformity may be consulted in the support SKtion of our Web site ,
accesSible from www.jbl.com
Federal Communication Commission Interference Statement
This equipmtnt has been testtd and found to comply with the limrts for a Class 8 digital devi<e,
pursuantto Part 15 of the FCC Rules. These limits are designed to provide reasonable protKtlon
against harmful intefference in a resldential installation . Thls equipment generates, uses and can
radiate radio frequency ent19Y and, If not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there Is no guarantee that
Interference will not occur In a particular installation. If this equipment does cause harmful
lnterlmnce to radio or televiSion reception, which ran be determined by turning the equipment
otr and on, the USfr is encouraged to try to corrKI the interference by one or more of the
following measures:
• Reorient or relocate the rece1V1ng antenna.
• Increase the separation between the equipment and rectiv'1 .
• ConnKt the equipment Into an outlet on a circuit differe11t from that to which the receiver ls
connected.
• Consult the dealer or an expenenced radio/fV tedmician for help.
Caution: Changes or modifications not expressly approved by HARMAN could void the user's
authority to operate the equipment
For Products ThatTransmit RF Energy:
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry Canada li<enst-exempt RSS standard(s).
Operation is subJect to the following two conditions: (1) This deYlce may not cause harmful
intefference; and (2) this device must accept any Interference received, Including interference
that may cause undesired operation.
FCC/IC Radiation Exposure Statement
This equipme11t complies with FCUIC RSS-102 radiation exposure limits set forth for an
uncontrolled environment
For WI-Fl SG clevke
FCC Caution:
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85
GHz bands. These radar stations can cause interference with andtor damage this device
No configuration controls are provided for this wireless equipment allowing any change In
the frequellCY of operations outside the FCC grant of authorization for US operation
according to Part 15.407 of the FCC rules.
IC Caution:
User should al10 be advised that:
(i) The device for operation in the band 5150 • 5250 MHz 1s only for indoor use to reduce
the potential for harmful interference to co-channel mobile satellite systems; {ii) the
maximum antenna gain permitted for devices in the bands 52$0 • 5350 MHz and
5470 · 5725 MHz shall comply with the e.l.r.p. lim1t: and
(in) The maximum antenna gain permitted for devices in the band 5725 • 5825 MHz shall
comply with the e.l.r.p. limitsspedfied for point-to-point and non point-to-point
operallon as appropriate.
(Iv) Users should also be advised that high-power radars are allocated as primary users
(i.e. priority users) of the bands 5250 - 5350 MHz and 5650 • 5850 MHz and that
these radars could cause Interference and/or damage to LE-LAN devices .