Harman JBL BAR 5.0 MULTIBEAM User Manual

www.jbl.com
English
1919
8. SOUND SETTINGS
Bass adjustment
• Check “Bass adjustment” under “6.2 Sound calibration” in
the “6. SETUP” chapter).
Audio sync
With the audio sync function, you can synchronize audio and
video to make sure that no delay is heard from your video content.
1. On the remote control, press and hold for more than three
seconds.
2. Within ve seconds, press + or - on the remote control to
adjust the audio delay and match with video.
→ The audio sync timing is displayed.
Smart mode
With the smart mode enabled by default, you can enjoy TV
programs with rich sound effects. For TV programs such as
news and weather forecasts, you can reduce sound effects by
disabling the smart mode and switching to the standard mode.
Smart mode: EQ settings and JBL Surround Sound are applied
for rich sound effects.
Standard mode: The preset EQ settings are applied for standard
sound effects.
To disable the smart mode, do the following:
1. On the remote control, press and hold for more than three
seconds. Press +.
→ Current mode is displayed. “ ”: The
smart mode is enabled.
2. Repeat Step 1.
→ You switch to another mode. “ ”: The
standard mode is enabled.
→ Next time you switch on the soundbar, the smart mode is
enabled again automatically.
9. RESTORE FACTORY SETTINGS
By restoring the default settings dened at factories. you remove
all your personalized settings from the soundbar.
• On the soundbar, press and hold and for more than
10 seconds.
→ “ ” is displayed.
→ The soundbar shows “ ” and “ ” and then,
goes to standby mode.

Harman JBL BAR 5.0 MULTIBEAM Specifications

General

Brand	Harman
Model	JBL BAR 5.0 MULTIBEAM
Category	Speaker System
Language	English