Harman JBL BAR 9.1 Owner's Manual

www.jbl.com
English
1515
2) Calibrate the speaker position
>5S
2-CALIBRATION
R
L
R
L
2DONE
1. Place the detachable rear speakers in your desired location.
2. On the remote control, press and hold
until
“ ” is displayed on the soundbar.
→ Countdown starts from 5 to 1.
→ Calibration tone is heard. Audio calibration starts.
→ “
”: Calibration ongoing.
→ “
”: Calibration of the speaker position is
completed successfully.
3. To select suitable surround sound, press
repeatedly to
switch between high, low or middle (default).
NOTES:
− During calibration, all buttons on the remote control are disabled
except for
and .
− “
” is displayed if calibration failed.
6.3.2 Dolby Atmos
®
/ DTS:X
®
With Dolby Atmos or DTS:X, overhead audio distribution is
provided for powerful 3D sound immersion.
1. To play the surround sound of DOLBY ATMOS or DTS:X,
connect and play your Blu-ray player or streaming device
as described under “Connection with your TV and digital
devices” in the “CONNECT” chapter.
2. To select suitable strength for Dolby Atmos or DTS:X, press
on remote control to switch between middle (default),
high, low or off.
HIGH
MID
LOW
MID
HIGH
LOW
R
L
L
R
R
L

Harman JBL BAR 9.1 Specifications

General

Brand	Harman
Model	JBL BAR 9.1
Category	Speaker System
Language	English