REMOTE IN
If you’re using line-level inputs to provide signal to the Basspro 8 (see below), uncouple the bullet connector on the
blue/white wire, and connect the longer wire marked with “REMOTE IN” to the remote output wire on your source
unit.
If you’re using speaker-level inputs to provide signal to the Basspro 8 (see below), you must leave the bullet
connector coupled so that the blue/white wire makes a loop.
When you’ve made all the necessary power and signal connections to the Basspro 8 wiring harness, plug the
harness into the input marked “INPUT”.
To Next Page
Loading...
