Harman JBL CLUB Series - Connecting the Amplifier

TECHNICAL DATA
Ω Ω
TECHNICAL DATA
Ω Ω
CONNECTING THE
AMPLIFIER
To connect the speaker wire coming from your
amplifier, push down on the terminal to expose
the connection hole. Thread the bare wire end
through the hole, then release the terminal to
secure. Be sure to observe proper wire polarity
for maximum performance.
Installation:
CLUB 102 CLUB 122
2.06..............4.4
0.748.............0.812
52.65.............52.65
339.79............339.79
8.65..............12.186
0.681.............0.693
19.2909...........19.6218
0.118.............0.12
124.77............124.021
41.5..............41.2
6.635.............4.229
0.894.............0.952
0.788.............0.777
0.315.............0.315
8 . . . . . . . . . . . . . . . .8
0.787.............0.787
20 . . . . . . . . . . . . . . .20
0.236.............0.236
6 . . . . . . . . . . . . . . . .6
2.02.............4.37
0.797............0.838
86.1.............86.1
555.72...........555.72
9.082............12.732
2.287............2.31
64.7667..........65.4183
0.148............0.15
163.711..........162.438
32.3.............32.3
8.933............5.082
0.813............0.888
0.746............0.756
0.315............0.315
8 . . . . . . . . . . . . . . .8
0.787............0.787
20 . . . . . . . . . . . . . .20
0.236............0.236
6 . . . . . . . . . . . . . . .6
10-17/32" (267.3 mm) 12-1/2" (317.8 mm)
9" (228.6 mm) 11-1/8" (282.65 mm)
21/32"
(16.5 mm)
9/16"
(14.5 mm)
5-3/4"
(146.3 mm)
6-1/16"
(153.7 mm)
5-1/8"
(129.8 mm)
5-1/2"
(139.2 mm)
2.58 73
0.92 26
41 32
7.87"
200mm
6.69"
170mm
0.92 2.58
26
73
2.76"
70 mm
3.54"
90 mm
10" (250mm)
83dB±2dB
350W RMS, 1050W PEAK
35Hz – 500Hz
2 or 4 Ohms, Switch-Selectable
2" (50mm)
12" (300mm)
86dB±2dB
400W RMS, 1200W PEAK
30Hz – 500Hz
2 or 4 Ohms, Switch-Selectable
2" (50mm)
(1W/1m): (1W/1m):
(-6dB): (-6dB):