Harman Mark Levinson 585 - Page 9

9
N
0
585 / N
0
585.5 INTEGRATED AMPLIFIER / OWNER’S MANUAL
ENGLISH
The Output section of the Setup menu lets you configure the
N
0
585’s outputs.
High Pass: This menu allows you to activate a 12dB/octave
Butterworth 80Hz high-pass filter on the N
0
585’s speaker
outputs. If you have connected a powered subwoofer to the
N
0
585’s Line Outputs and want to restrict the low frequencies
sent to your system’s main speakers, set the Hi Pass filter to On.
Line Out: This menu lets you set the N
0
585’s Line Outputs to
Fixed or Variable:
Fixed: Use this setting when you have connected the Line
Outputs to a recording device. The Line Outputs will remain
at a fixed level regardless of the N
0
585’s volume control level.
Variable: Use this setting when you have connected the Line
Outputs to a powered subwoofer or to an external amplifier.
The Line Output level will vary with the level of the N
0
585’s
volume control.
PwrAmp: This menu lets you enable or disable the N
0
585’s
power amplifier, such as when you are using your N
0
585 in a
multi-zone system or with an upgraded power amplifier.
SETUP MENU
OUTPUT
Output
High Pass
Line Out
PwrAmp
Setup Menu
Input Setup
Power Mgmt
Volume Control
Advanced
Output