Harman P35I - I. Flame Guide Extension; J. Optional Trim Kit; K. Service Rail Kit- #1-00-774125

22
Save These Instructions3-90-775R36_09/15
J.OptionalTrimKit*
The trim kit option includes a door frame and an ash lip
trim. To install the ash lip trim, simply slide it over the ash
lip from the front. You can secure it with a few dabs of high
temperature silicone, if desired. To install the door trim,
follow these steps.
• Removethedoorlatchbylooseningthesmallset-screw
and tapping out the roll pin.
• Remove the door by lifting it off of the hinges. Lay it, face
downonaatsurface.
• Locate and drill the
dimpled holes in each
corner of the door, using
the provided drill bit.
• Install the trim frame
with the threaded studs
through the holes in the
door, and secure it with
the four nuts provided in
thekit.
Set-screw
Roll Pin
K.ServiceRailKit-#1-00-774125
The Service Rail Kit is used to support the insert body
while it is pulled out of the mounting frame for cleaning or
service. Used only with a raised hearth installation, it is
easily adjustable to a height range of 4" to 14". Assemble
the rail kit using the provided instructions.After removing
the Ash Pan cover, the rails attach to the mounting frame
with four bolts. There are even stop bolts on the rails to
preventaccidentalroll-off.
*TrimnishPartNumbers;
3-43-06797-7=ModernBrushedStainless
1-00-00775-7=LeafBrushedStainless
1-00-00775-8=LeafBrightNickel
I. Flame Guide Extension
OncetheameguideisinstalledtheFlameGuideExtension
shouldbeinstalledbyslidingitinbehindtheameguideas
shown below. Notice the bend points away from the Heat
Exchanger.
BURN POT
CAST FLAME GUIDE
STEEL FLAME GUIDE EXTENSION
HEAT EXCHANGER
BENDS AWAY FROM HEAT EXCHANGER
Two bolts on each side secure the rail
kittothemountingframe.