Harman P35I - D. Before Your First Fire; E. Draft Test Procedure

26
Save These Instructions3-90-775R36_09/15
D.BeforeYourFirstFire
• Be sure the appliance is installed properly and that
all safety requirements have been met. Pay particular
attention to the clearances to combustibles, oor
protection and the venting instructions.
• Testyour smoke detector(s)andCO detector(s) tothe
specicationsofthemanufacturer.
• Doublecheckthattheashpanandinternalreboxare
empty.
• Be sure to read this entire manual.
E.DraftTestProcedure
• Usinga9/16"wrench,removethedrafttestportplugbolt,
located to the left inside the rebox. This bolt threads
downward through the outside of the body. Externally,
the opened hole is located above the ash pan spring
latch on the left.
• Insert the draft meter hose into the test port.
• Be sure the meter is capable of a scale between 0 and
1inchWaterColumn.Zerothemeterifnecessary,and
be sure it is set up to read in negative pressure.
• Be sure the ash pan, door, and hopper lid are all closed
and latched.
• Turn the Feed Limit dial to "Test" mode.
• During the rst minute of test, the combustion blower
will be on high. Record the high draft reading here
____________-W.C. The high draft should be above
-0.5"W.C.butnohigherthan-1"W.C.
• After a minute, the combustion blower will go to low
speed.Hereyouwanttoseeareadingbetween-0.30"
and -0.35". If necessary, adjust the draftvoltage using
the low draft adjustment screw on the circuit board (See
Page24).Clockwisewillincreasethedraftandcounter-
clockwisewilldecreaseit.
• Onceset,recordthelowdraftreadinghere:___________
-W.C.
• Be sure and turn off of "Test" mode. Disconnect the
meter and return the plug bolt to the test port.
The optimal method of operation is in Room Temp
mode, with the Ignition switch set to Automatic.
TESTED AND APPROVED FOR USE WITH WOOD
PELLETS ONLY. USE OF ANY OTHER TYPE OF FUEL
WILL VOID THE APPLIANCE WARRANTY.
WARNING
!
"NEVER USE GASOLINE, GASOLINE-TYPE
LANTERNFUEL,KEROSENE,CHARCOAL
LIGHTER FLUID, OR SIMILAR LIQUIDS TO
START OR "FRESHEN UP " A FIRE IN THIS
HEATER.KEEPALLSUCHLIQUIDSWELL
AWAY FROM THE HEATER WHILE IN USE".
WARNING
!
DRAFT BOLT