Harman PC45 - Automatic Start Up; Starting the Fire Automatically; Burning Corn and Pellets

15 pC 45 Corn/pellet Stove
3-90-02686R29_05/14
Automatic Start Up
Fig. 21
6
4
5
2
3
1
MAX.
CORN
TEST
F
E
E
D
A
D
J
U
S
T
E
R
P
E
L
L
E
T
O
N
L
Y
C
O
R
N
-
P
E
L
L
E
T
Starting the Fire
Igniter Switch to "AUTO" (up position)
Make sure the unit is plugged into a 120 VAC, 60 Hz
electricalsource.Thepowerlightshouldbetheonlylightlit.
Anytimethereisaninterruptioninpoweratthereceptacle,
thecombustionblowerwillrunfor1minuteafterthepower
isrestored.Thecontrolusesthistimetodetermineexhaust
temperatureandifthereisaneedtoremainon.
BE SURE THERE IS NO FUEL OR OTHER COMBUSTIBLES
IN THE ASH PAN PRIOR TO LIGHTING.
1. TurntheModeSelectorto"OFF"
2. Fillthehopperwithcornorpellets.
3. Cleantheburnpotandhousing,ifnecessary.
4. Ifstartingafteranemptyhopper,turnthefeedadjusterto
"TEST"untilthefuelisvisibleintheaugertubeopening.
Fig 21, This also allows you to check the motors for
operation.
NOTE:Theaugermotorwillnotoperatewiththeviewdoor
orashdooropen.
NOTE:Theinitialstart-uponanewstovemayrequirethe
corntobepurgedintotheburnpotareabeforecontinuing
tostep5.
5. Turnthefeedadjusterto#2(corn)or#4(pellet)
6. Fliptheigniterswitchupintothe"AUTO"position.
7. Turnthetemperaturedialtothedesiredsetting.
8.TurnthemodeselectordialtoRoomTemperatureorStove
Temperature.
9. Fillthehopperwithcornorpelletsandremovetheashes
asrequired.
CAUTION
!
DO NOT CONNECT TO ANY AIR DISTRIBUTION
DUCT OR SYSTEM.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
SUCH AS GASOLINE, NAPTHA, OR ENGINE OIL.
HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHING, AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS.
KEEP FIREBOX AND ASH REMOVAL DOORS
CLOSED DURING OPERATION. MAINTAIN SEALS IN
GOOD CONDITION.
WARNING
!
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP " A
FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS
WELL AWAY FROM THE HEATER WHILE IN USE.