Harman PC45 - Grain Cap Installation

12PC 45 Corn/Pellet Stove
3-90-02686R29_05/14
Grain Cap Installation
Grain Cap
Thegraincapisdesignedtoenhancetheburnqualityofthe
fuelbeingburned(i.e.eldcorn,wheat,barley,rye,oats,
etc.)Itspurposeisto reect more heat into the burn pot.
Thispromotesamorethoroughburningofthefuelandless
ash.Dependingonthequalityofthefuelbeingburned,the
effectivenessofthegraincapmayvary.
Thegraincapwillneedtoberemovedforcleaning.Thispart
isclassiedasaconsumableitemandisexcludedfromthe
productwarranty.
Installation:
1. Hooktheslotonthegraincapovertheliponthesiderail
oftheburnpot,asshown.
2. Allowthegraincaptorestontotheburnpotsides.
Grain Cap
Burn Pot
Fig. 18
Burn Pot with Smaller Holes
ThePC45stoveisbuiltwithaburnpotthathas.125(1/8")
combustionairholes.Thisgratehasnoidentifyingmarks.
Includedwithyourstoveisanadditionalgratethathas.0625
(1/16")combustionairholes.Thisgratecanbeidentiedwith
etchingsonthebottomside.An‘S’isetchedononeendand
‘724208’isetchedattheotherend.
Dependingonthetypeandthemoisturecontent,somecorn
orgrainwillburnbetterwiththesmallerholesforcombustion
air,whileothersmayworkbetterwiththelargerholes.
To change the burn pot grate, rst remove the end gate
retainerandtheendgate.Pulltheaugerextensionfromthe
auger,andliftthegrateoutoftheframe.Placethenewgrate,
installtheaugerextension,replacetheendgateandretainer
clip.Refertothediagramsonthenextpageforguidance.
The PC45 is built with this burn pot
that has larger holes, Part #1-10-
724108.
You may opt to change the burn
pot to this version with smaller
holes. This option has the letter
"S" marked on it. Part # 1-10-
724208.