EasyManua.ls Logo

Harman PC45 - Page 27

Harman PC45
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27 pC 45 Corn/pellet Stove
3-90-02686R29_05/14
Optional Trim
There are three different nishes to choose from, gold,
brushedstainless,andbrightnickel.Eachtrimkitincludesa
doorframe,adrillbitfortheloaddoorholes,anashdoortile
trim,andanashfendertrim.Theashdoortileframecanbe
installedwithorwithoutthedecorativetile.Fig.41.
Toinstallthedoorframe,laytheframefacedownonasoft
surface.Fastendoorframebyinsertingthe4threadedposts
ontheframethroughthedoor.Thepostsshouldlineupwith
the4holeslocatedatthecornersofthedoor.Oncetheposts
arethroughthedoor,fastenframewith4nutsandtighten
untiltheframeissnug.
Toinstallashliptrim,simplyslidethetrimovertheashlip
andintothegrooveonthetrim.
Theashdoorframeincludesabentspringclip.Insertthe
springclipintooneendoftheframe.Starttheframeintothe
recessedareaoftheashdoorwiththeclipendrst.Push
tensiononthespringclipwhileinsertingtheotherendofthe
frameintotherecess.
Decorative Tile
Decorative tile is available in four choices of slate or a
brushedstainlessdeercutout(shownbelow).Thetileinstalls
behindthetrimontheashdoor.
Cleaning Plated Trim
Goldornickel platedhardwareshouldneverbe buffedor
polished.Abrasivecleansersandmetalpolisheswillremove
theplatingandthereforeshouldneverbeused.Iftheplating
needstobecleaned,waituntilthestoveiscompletelycool,
thenuseasponge,soapandwatertogentlyremovedirtand
stains.Beforerelightingthestove,removeallsoapresidue
andwipedry.
Direct Vent Wall Pass-through
Thedirectventwallpass-throughallowsyoutobringoutside
air in for combustion, and safely pass your pellet venting
throughthewallwhileonlyneedingtomakeonehole.The
passthroughisadjustablefordifferentwallthicknessfrom
4½"to10⅛"thick.Item#1-00-677077iscompatiblewith3"
ventingonly.
Options
Optional Hopper Screen (Corn Strainer)
Thehopperscreen/cornstrainerwasdesignedtosiftthecorn
asitisloadedintothehopper.Thissiftingwillcatchunwanted
materialsfrombeingburned.The strainer also includesa
removablefunneltoaidinfuelhandling.
Burnpot Grates
ThePC45includestwoburngrates.You'llnoticethatthey
eachhavedifferentsizedairholesinthem.Usethegratethat
tsyourfuelthebest.Inmostcases,thesmallerholeswill
bebestwithcornandthelargeholeswillbebestforpellets.
Feelfreetoexperimentwithbothgrates.
Fig. 41
Inner half
Outer half

Related product manuals