Harmony Lite - Setting Programmable Positions and Pairing Remote

PAIRING REMOTE
STEP 1
Make sure the baeries work fine.
Replace them when needed.
STEP 2
Plug the power cord to the power source.
The original remote that comes in the box is already paired to the
foundaon. No further acon is required.
In the event that the remote is not paired with the foundaon, follow
the steps below.
STEP 3
Press and hold head li and foot li simultaneously, then press and
hold the buon on the cord of control box for 3 seconds unl your
hear 2 beeps sound, the remote is then paired.
STEP 3
Setting Programmable Positions and Pairing Remote
SETTING PROGRAMMABLE POSITIONS
To adjust the saved posion, repeat steps 1 and 2 and the new
posion will be saved.
STEP 1
Adjust the head and foot to your desired posion.
STEP 2
Press and hold the flat buon first, then press and hold memory
buon for 5 seconds unl you hear 2 beeps sound.
The wireless power bed has a programmable feature that allows you
to save custom posions.
Please read all the instrucons below before seng your custom
presets on the remote.
-11-
Pairing Buon