HART HLST01 - Storing the Trimmer; Replacement Parts; Troubleshooting

9 – English
MAINTENANCE
Insert the line into the anchor hole in the upper part of the
spool.Windthelinearoundtheupperpartofthespool
clockwise,asshownbythearrowsonthespool.Place
lineintheslotonupperspoolflange,leavingabout6in.
extendedbeyondtheslot.Donotoverfill.Afterwinding
the line, there should be at least 1/4 in. between the
woundlineandtheoutsideedgeofthespool.
Replacetheplasticretainer,spool,andthespoolretainer.
RefertoSpool Replacement earlierinthismanual.
STORING THE TRIMMER
Removethebatterypackbeforestoring.
Cleanallforeignmaterialfromthetrimmer.
Storeitinaplacethatisinaccessibletochildren.
Keepawayfromcorrosiveagentssuchasgardenchem-
icalsandde-icingsalts.
REPLACEMENT PARTS
0.065in.DiameterRound
ReplacmentSpool............................................ HAC165RL
0.080in.TwistedReplacmentSpool............... HAC180RL
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Linewillnotadvancewhenusing
the auto-feed head
Lineisweldedtoitself.
Notenoughlineonspool.
Lineisworntooshort.
Lineistangledonspool.
Lubricatewithsiliconespray.
Installmoreline.RefertoLine Replace-
ment earlierinthismanual.
Pulllinewhilepressingbutton.
Remove line from spool and rewind.
Refer to Line Replacement earlier in
thismanual.
Grass wraps around boom
housing and string head
Cuttingtallgrassatgroundlevel. Cut tall grass from the top down to pre-
ventwrapping.
Motor fails to start when switch
trigger is depressed
Batteryisnotsecure.
Batteryisnotcharged.
Shaft not connected completely
To secure the battery pack, make sure
thelatchsnapsintoplace.
Charge the battery pack according to the
instructionsincludedwithyourmodel.
Make sure shaft trimmer is securely
seatedinthecoupleronthepowerhead.