HART HTEDG User Manual

7 – English
OPERATION
USING THE EDGER ATTACHMENT
See Figure 3.
WARNING:
Enginehousingongaspowerheadsmaybecomehot
duringedgeroperation.Donotrestorplaceyourarm,
hand,oranybodypartagainsttheenginehousingduring
edgeroperation.Onlyholdtheedgerasshowninfigure
3withallbodypartsclearofenginehousing.Extended
contactwiththeenginehousingcanresultinburnsor
otherinjuries.
WARNING:
Alwayspositiontheunitontheoperator’srightside.The
use of the unit on the operator’s left side will expose
theoperatortohotsurfacesandcanresultinpossible
burninjury.
WARNING:
Toavoidburnsfromhotsurfaces,neveroperateunitwith
thebottomoftheengineabovewaistlevel.
Whenusingtheedgerattachment,holdtheunitwithyour
righthandontherearhandleandyourlefthandonthefront
handle.Keepafirmgripwithbothhandswhileinoperation.
Theedgershouldbeheldatacomfortablepositionwiththe
rearhandleabouthipheight.
NOTE:Whenusedwithagaspowerhead,alwaysoperate
atfullthrottle.Prolongedcuttingatpartialthrottlewillresult
inoildrippingfromthemuffler.
ADJUSTING DEPTH OF CUT
See Figures 4 - 5.

Stoptheengineormotorandremovethesparkplugwire,
disconnectfromthepowersupply,orremovethebattery
pack.

Loosentheadjustingknobandmovethewheelarmup
toincreasethedepthordowntodecreasethedepth.

Afteradjustmentiscomplete,tightentheadjustingknob
securely.

Replacethesparkplugwire,connecttothepowersupply,
orreinstallthebatterypackandstarttheunit.
NOTE: Adjust the blade depth from1/2 in. to 1 in. deep
initially.Makeashallowcuttotestthecuttingdepth.Ifthe
cuttingdepthneedsadjusting,thisshouldbedoneprogres-
sivelyuntilthedesireddepthisreached.
OPERATING TIPS

Theedgerwilledgealongsidewalks,driveways,flower-
beds,curbs,andsimilarareas.

Usethearrowguideonthebladeguardtoaligntheblade
withtheedgingsurface.

Cutatasteadypace.Ifthebladebeginstobogdown,
youareedgingtoofast;slowyourpace.Donotforcethe
bladeintotheground.

Light contact of the blade against the sidewalk edge,
curb,etc.,isacceptableandwillnotdamagetheedger.

Bestappearanceis obtained when grass is dry. Avoid
edginginwetsoilorwetgrassareasorthebladeguard
might clog and result in an uneven edge. If the blade
guardbecomes clogged, stop the engine, remove the
sparkplug wire,disconnectfromthe powersupply,or
removethebatterypack,thenremovedebrisfromthe
bladeguard.

HART HTEDG Specifications

General

Brand	HART
Model	HTEDG
Category	Edger
Language	English