Need help?Do you have a question about the Hartke Transient Attack 1400 and is the answer not in the manual?
Audio Specifications| rated output power | 146 W |
|---|---|
| total harmonic distortion | 0.05% |
| signal to noise ratio | -68.6 dB |
Frequency Response| frequency response at 20 Hz | -11.3 dB |
|---|---|
| frequency response at 40 Hz | -0.4 dB |
| frequency response at 20 kHz | -6.2 dB |
Input and Output Levels| input sensitivity | 10.8 mV |
|---|---|
| idle current | 10 mV |
| dc offset voltage | 0 V ± 100mV |
Equalizer Settings| low frequency equalizer | 33 Hz ±15 dB |
|---|---|
| low mid frequency equalizer | 80 Hz ±15 dB |
| high mid frequency equalizer | 240 Hz ±15 dB |
| high frequency equalizer | 2.5 kHz ±15 dB |
Compressor Effect Levels| compressor input level at -39 dB | 5.2 dB |
|---|---|
| compressor input level at -29 dB | 3.1 dB |
| compressor input level at -19 dB | 1.8 dB |
| compressor input level at -9 dB | 0.9 dB |
Noise and Output Levels| residual noise | -56 dB |
|---|---|
| send output level | 0 dBM |
| return input level | 0 dBM |
Headphone Output| headphone level R | 275 mW |
|---|---|
| headphone level L | 275 mW |
Connect bass guitar, effects processors, and use as direct output.
Adjusts overall level and engages the contour switch for tube amp emulation.
Four bands (Low, Low Mid, High Mid, High) for detailed tone shaping.
Indicates power status and compression/limiting activity.
Controls for engaging compression and powering the unit on/off.
Connect headphones for practice; mutes speaker output.
Location for inserting a replacement fuse for proper operation.
Connect bass speaker cabinets to the amplifier output jack.
Includes rated power, distortion, noise, frequency response, and input sensitivity.
Details equalizer, compressor, residual noise, idle current, and DC offset.
Specifies levels for effects loop send/return and headphone output.
To Next Page
