Need help?Do you have a question about the Hartke 2000 and is the answer not in the manual?
General| Inputs | 1/4" instrument input |
|---|---|
| EQ | Bass, Treble |
| Type | Bass amplifier |
| Outputs | 1/4" line out, XLR out |
| Channels | 1 |
| Power Output | 200 watts |
Connects passive or active bass guitars to the amplifier.
Adjusts tube and solid state preamplification levels.
Adjusts peak signal reduction and compression ratio.
Sliders for boosting/attenuating ten narrow-band frequencies.
Adjusts broad-band low and high frequencies for tone shaping.
Controls overall output volume, power switch, and LED status.
Contains fuse holder and power connection.
Cooling fan and high-pass filter switch for speaker protection.
Connects external effects processors for send and return.
Connects bass cabinets to the amplifier.
Connects passive or active bass guitars to the amplifier.
Adjusts tube and solid state preamplification levels.
Visual indicator for compression and limiting status.
Adjusts peak signal reduction and compression ratio.
Sliders for boosting/attenuating ten narrow-band frequencies.
Adjusts broad-band low and high frequencies for tone shaping.
Controls overall output volume, power switch, and LED status.
Contains fuse holder and power connection.
Connects cabinets and provides cooling.
Connects effects processors and adjusts effect mix.
Adjusts signal routing and ground lift for direct output.
Connecting cabinets, power, and bass instrument for operation.
Adjusting volume, pre-amps, and other controls for desired sound.
Connecting and using effects pedals or processors with the amp.
Adjusts broad frequency bands for tone shaping.
Fine-tunes tone using ten narrow frequency bands.
Provides guidance on achieving specific bass tones.
Adjusts peak reduction and provides status indication.
Explains how compression evens notes, adds punch, and protects speakers.
Step-by-step guide to changing the amplifier's mains voltage.
To Next Page
