To Next Page
S
spadillaAug 6, 2025
What to do if the load does not dry in the drying cycle of HARVEY Hydroclave MC10?
- CChristopher HuberAug 6, 2025
If your load is not drying in the drying cycle of your HARVEY Laboratory Equipment, consider these potential causes and solutions: * **Inadequate drying time:** Try increasing the drying time. * **Delayed door opening:** Ensure you open the sterilizer door immediately after the sterilize cycle finishes. * **Excessively wet load:** Check the load size, ensure items aren't touching chamber walls, and verify proper loading according to the 'Load Chart' and 'Loading' procedures. If using the open door drying method, keep the door open approximately 1/4" (push the latch down while the door is open).
General
