HARVEY Hydroclave MC8 - User Manual

HARVEY Hydroclave MC8

56 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

1

BARNSTEAD THERMOLYNE CORPORATION

Harvey

®

Hydroclave MC8

Hydroclave MC10

Steam Sterilizer

(With Optional Non-Recirculating System)

OWNER AND OPERATOR MANUAL

Table of Contents

Questions and Answers

U
ugriffithAug 2, 2025
What to do if the load does not dry in the drying cycle of HARVEY Hydroclave MC8?
- T
  Tiffany MorganAug 2, 2025
  If your load is not drying in the drying cycle of your HARVEY Laboratory Equipment, consider these potential causes and solutions: * **Inadequate drying time:** Try increasing the drying time. * **Delayed door opening:** Ensure you open the sterilizer door immediately after the sterilize cycle finishes. * **Excessively wet load:** Check the load size, ensure items aren't touching chamber walls, and verify proper loading according to the 'Load Chart' and 'Loading' procedures. If using the open door drying method, keep the door open approximately 1/4" (push the latch down while the door is open).
S
Shawn BrownAug 15, 2025
Why are wrapped loads wet after sterilize cycle in HARVEY Laboratory Equipment?
- E
  Eric RiosAug 15, 2025
  If wrapped loads are wet after the sterilize cycle in your HARVEY Laboratory Equipment, it might be due to improper loading. Make sure the wrap isn't touching the chamber walls and, if you have a 10" chamber, avoid placing wrapped goods on the bottom of the tray rack.

Summary

Operator Maintenance

Daily and Weekly Maintenance

Routine daily and weekly checks, cleaning, and inspections for the sterilizer.

Periodic and As-Needed Maintenance

Scheduled cleaning of reservoir, filters, and when-required tasks like gasket replacement.

Introduction

Sterilizer Operation Overview

General explanation of the sterilizer's operating principle and features.

Sterilizer Operation Details

Describes the sequence of events during sterilizer operation.

Safety Information

Safety Alert Signals and Symbols

Explanation of warning, caution, and note symbols for safe operation.

Equipment Symbols Defined

Identifies and explains various symbols found on the sterilizer equipment.

General Description

Intended Use and Operating Features

Specifies the designed purpose, applications, and key functionalities of the sterilizer.

Printer and Accessory Options

Details the optional printer and non-recirculating water accessory.

Operation

Initial Preparation and Setup

Powering on, filling the reservoir, and preparing the unit for use.

Sterilization Cycle Management

Preparing items, loading, selecting, executing, and monitoring cycles.

Drying and Load Removal

Procedures for drying the load and safely removing it from the chamber.

Additional Information

Cycle Control and Emergency Procedures

Procedures for cancelling cycles, emergency power off, and handling power failures.

Diagnostic Messages

Diagnostic Messages and Solutions

Lists diagnostic messages and the corresponding actions to resolve them.

Troubleshooting

Troubleshooting Common Problems

Provides solutions for common problems encountered during operation.

Printer

Printer Installation and Maintenance

Instructions for installing, operating, and maintaining the sterilizer's printer.

Recommended Spare Parts

Recommended Spare Parts List

Lists essential spare parts and their part numbers for prompt replacement.

Installation

Setup Procedures

Steps for leveling, clearance, electrical connection, and accessory installation.

Configuration Settings

Setting the clock, calendar, units, and other operating parameters.

Appendix

Voltage Conversion Procedures

Instructions for converting the sterilizer between 115V and 230V.

HARVEY Hydroclave MC8 Specifications

General

Brand	HARVEY
Model	Hydroclave MC8
Category	Laboratory Equipment
Language	English

Related product manuals

HARVEY Hydroclave MC10

Preview: HARVEY Chemiclave EC5500

HARVEY Chemiclave EC5500

HARVEY Chemiclave EC6000