25
For more efficient drying, opening the door is
strongly recommended. (See Open Door
Drying procedure).
At the end of closed door drying, three groups
of three beeps will sound and the COMPLETE
indicator lights.
To cancel drying phase in progress, press the
STOP switch.
Open Door Drying
1. Unlock and open the door. Two beeps
will sound and the indicator lights will
turn off.
2. Push down on the door latch so that
the door will remain ajar.
3. Press START to begin drying phase.
The DRYING indicator will light.
4. At the end of the drying phase, three
groups of three beeps sound, and the
COMPLETE indicator will turn off after
60 seconds.
5. The open door drying phase may be
repeated by leaving the door open and
pressing START twice.
OPERATION
Note
Thirty minutes may be needed
for wrapped loads of 6 to 10 lbs.
in a single tray. Double tray loads
may require slightly more time
and unwrapped items less drying
time. Several trial cycles may be
necessary to determine a
suitable drying time for your type
of load situation.
Warning
Burn Hazard: To prevent burns
from escaping steam, always
stand back (behind door) when
opening the door.
Note
Closed door drying will stop
when the door is opened. When
START is pressed to begin open
door drying, the timer will be
reset to the programmed drying
time.
The open door drying time is
limited to the selected closed
door drying time. If zero was
selected, open door drying is not
possible.
Figure 13
Drying Cycle Operation
Latch Handle
Down With
Door Open
Door Slightly
O
pen
(Approx. 1/4”)
Latching
Bars
To Next Page
Loading...
