43
INSTALLATION
Setting the Clock/Calendar
1. Plug in the power cord, but do not
press controls ON.
The software will perform a self-test,
then the time and date will be
displayed.
2. Press PROGRAM/SET switch.
a. The hour will flash:
Use the UP arrow to set the hour
ahead or the down arrow to set it back.
When the clock is set to the correct
hour, press PROGRAM/SET to store
the hour in memory.
b. The minute will flash:
Use the arrows to set the minute.
Press PROGRAM/SET to store.
c. The AM/PM indicator will flash:
Press either arrow to alternate
between AM and PM. Press
PROGRAM/SET to store.
12:00 AM
JAN 01 1998
12:00 AM
JAN 01 1998
12:00 AM
JAN 01 1998
To Next Page
Loading...
