20
Installing Overflow Tube
(Optional)
If the sterilizer is located within 5 ft. (1.5 m) of a
sink or drain, the overflow tube may be used. The
collection bottle will not require emptying while
the automatic overflow is used.
1. Push the overflow tube (supplied) into
the upper quick connect on the back of
the cooling tank.
2. Push the tube connector in until it
“clicks.”
3. Place the end of the overflow tube in a
sink or drain.
OPERATION
Load Chart
Note
The sink or drain must be below
the level of the cooling tank for
the water drain.
Note
Be sure to select the correct
cycle for the type of load.
Sterilization cannot be assured if
maximum load size and density
are exceeded. Total specified
weight should not be exceeded
for any sterilizer cycle.
Note
Use the LIQUIDS cycle to
process glassware.
Caution
Be sure items can withstand
cycle temperature before placing
them in sterilizer. If in doubt,
refer to device manufacturer’s
instructions.
Warning
Volatile Reaction: Do not use
this equipment for processing
volatile substances or for any
purpose other than its intended
design. Failure to observe this
warning could cause personal
injury or damage to equipment.
Warning
Burn Hazard: To prevent the
possibility of injury from liquids
boiling over and/or containers
exploding, use only self-venting
automatic sealing stoppers
recommended by manufacturers
when processing all container
liquids or media.
To Next Page
Loading...
