© 2015 Hasbro. All rights reserved.
Furblings FAQs
How do I turn Furblings On/Off?
Similar to previous Furbys, Furblings do not have an on/off switch. They
are only activated when the head button is pressed.
How do I install the batteries?
1. Loosen 1 screw using a Phillips or flat head screwdriver from the plastic
base of the Furbling.
2. Remove the base2. Remove the base
3. Insert 3 LR44 (A76) button cell alkaline batteries
4. Replace base and tighten screw
Where can I find the date code on my Furbling?
Furblings date code is in the form of a hot stamp. It is located inside the
battery compartment, closest to the front left foot.
There is a high pitched tone coming from my Furbling and/or my iOS There is a high pitched tone coming from my Furbling and/or my iOS
device.
The noise you are hearing is how Furblings communicate with the mobile
device and other Furbys. Some people may hear it, others will not. Some
animals may also hear the noise. Don't worry, the tone will not cause any
harm to people or animals.
I changed the batteries in my Furbling to fresh/new alkaline batteries I changed the batteries in my Furbling to fresh/new alkaline batteries
and it is still acting "weird". How do I fix it?
Push and hold the refresh button (located on the base of the Furbling) for 2
seconds, then release.
My Furbling fell asleep and I can't seem to wake him up.
Push and hold the refresh button (located on the base of the Furbling) for 2
seconds, then release.
Furblings Cleaning InstructionsFurblings Cleaning Instructions
Gently brush your Furblings hair with a cloth or soft brush to loosen any
dirt. Then use a SLIGHTLY damp cloth to remove any stains. DO NOT put in
the washing machine, submerge in water or get Furbling wet in any way
other than using a slightly damp cloth. DO NOT use detergents or stain
removers on the fur.
To Next Page
Need help?
General