© 2015 Hasbro. All rights reserved.
Furby 2012 FAQs
How do I turn Furby On/Off?
Similar to Furby 1.0, Furby Party Rockers do not have an on/off switch.
To turn it off try the following:
1. Place Furby in quiet room and do not play with it.
2. Remove the batteries.
3. Using the Furby App, put Furby to sleep (Lulla Baah feature).
How do I install the batteries?How do I install the batteries?
1. Loosen 2 screws using a phillips head screwdriver (cross) from the
plastic base of Furby
2. Remove the base
3. Insert 4 AA alkaline batteries
4. Push the refresh buton for 2 seconds
5. Replace base and tighten screws
Where can I find the datecode on my Furby?Where can I find the datecode on my Furby?
Furbys date code is in the form of a hot stamp. It is located inside the
battery compartment, visible from the rear closest to the tail.
There is a high pitched tone coming from Furby and/or my iOS
device.
The noise you are hearing is how Furby communicates with the The noise you are hearing is how Furby communicates with the
mobile device and other Furbys. Some people may hear it, others will
not. Some animals may also hear the noise. Don't worry, the tone will
not cause any harm to people or animals.
I changed the batteries in my Furby to fresh/new alkaline batteries
and it is still acting "weird". How do I fix it?
Remove the base of Furby and push the refresh button for 2 seconds, Remove the base of Furby and push the refresh button for 2 seconds,
then replace the base. This will reset the hardware while retaining all
of the personality data.
My Furby fell asleep and I can't seem to wake him up.
Remove the base of Furby and push the refresh switch for 2 seconds,
then replace the base. This will reset the hardware while retaining all
of the personality data.
To Next Page
Need help?
General
