© 2015 Hasbro. All rights reserved.
Party Rockers FAQs
How do I turn Furby Party Rockers On/Off?
Similar to Furby 1.0, Furby Party Rockers do not have an on/off switch. To
turn it off try the following:
1. Place Furby in quiet room and do not play with it.
2. Remove the batteries.
3. Using the Furby App, put Furby to sleep.
How do I install the batteries?How do I install the batteries?
1. Loosen 1 screw using a phillips head screwdriver (cross) from the
plastic base of Furby
2. Remove the base
3. Insert 3 AAA alkaline batteries
3. Push the refresh buton for 2 seconds
4. Replace base and tighten screws
Where can I find the datecode on my Furby?Where can I find the datecode on my Furby?
Furbys date code is in the form of a hot stamp. It is located inside the
battery compartment, visible while looking direcly into the compart-
ment.
There is a high pitched tone coming from Furby and/or my iOS device.
The noise you are hearing is how Furby communicates with the mobile
device and other Furbys. Some people may hear it, others will not. Some
animals may also hear the noise. Don't worry, the tone will not cause any
harm to people or animals.
I changed the batteries in my Furby to fresh/new alkaline batteries and
it is still acting "weird". How do I fix it?
Remove the base of Furby and push the refresh button for 2 seconds, then Remove the base of Furby and push the refresh button for 2 seconds, then
replace the base. This will reset the hardware while retaining all of the
personality data.
My Furby fell asleep and I can't seem to wake him up.
Remove the base of Furby and push the refresh button for 2 seconds, then
replace the base. This will reset the hardware while retaining all of the
personality data.
To Next Page
Need help?
General