HASE COMO - Adding Fuel; Heating at Nominal; Thermal Output; Banking the Fire and Raising the................... Temperature; Heating With Brown Coal Briquettes

35
8. Heating with Brown Coal Briquettes
Woodshould be used for the warming-up phase
andwhenaddingfuelforthersttime,see“Warm-
ing-upPhase”.Assoonasabasicglowingrebed
isreached,place2-3browncoalbriquettesonthe
grateinthemiddleoftherebox,keepinganger’s
widthbetweenthebriquettes,andusethefollowing
procedure and settings:
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Openprimaryaircom-
pletely.
Adjust secondary air.
Pull primary air slider all
thewayout(g.5)
Set secondary air slider
toposition2.(g.5)
Place2briquettesonto
the grate.
Openregrate. Pulloutregrateslider.
Tab. 3
g. 5
9. Banking the Fire and Raising the
Temperature
Keep the stove set as described above until the
brown coal briquettes are thoroughly burnt. Then
closetheprimaryair(I)andtheregrate.Slidethe
secondary air slider (II) to position 2/3.
CAUTION!
While the stove is in operation, the sec-
ondary air slider should never be com-
pletely closed.
Toraisethetemperatureofthere,stiruptherest
of the glowing embers with the re grate slider.
Opentheprimaryair (I)and addnew logsto the
re.
7. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the re when the
ames from the previous burningoff phase have
just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and
secondary air.
Close primary air slider
(I),setsecondaryair
slider (II) between posi-
tion2and3.(g.4)
Closeregrate. Pushinregrateslider.
Add two logs weighing
approx.1,7kgintotal.
Place logs with one end
tothefrontofrebox.
Onlyaddasinglelayer
of fuel.
Tab. 2
g. 4