EN
3
•
DO NOT stand too close in front of the flash unit when it is activated,
or eyesight may be temporarily affected.
•
The built-in SSD of the digital back is for temporary data storage
only. Make sure to back up data in time to prevent data loss. When
the digital back is stored for an extended period (approximately one
year) with its power off or due to environmental factors such as high
temperature, SSD data may be damaged or lost.
•
Make sure that the memory card used is in good condition. DO NOT
remove the memory card when the status LED on the digital back is
blinking. Otherwise, the data may be lost, and the memory card may be
damaged.
•
Respect the privacy of others when using the devices. Make sure to
comply with local regulations and privacy laws.
2. Storage and Transportation
•
If the digital back will not be in use for an extended period, back up
the SSD data, remove the battery, and store the digital back in a dry
and well-ventilated location. It is recommended to use a camera dry
box, dehumidifier cabinet, or silica gel sachets.
•
Place the devices out of the reach of children.
•
DO NOT place heavy objects on the devices.
•
DO NOT store the devices in an environment with a temperature
higher than 45° C (113° F) or lower than -10°C (14° F).
3. Maintenance
•
Keep the devices clean and free of dirt and buildup. Attach the
protective cover to the digital back or camera body when the lens or
camera is detached. Otherwise, dust and dirt may be attracted to the
sensor.
•
The devices are delicate. Follow the instructions strictly in the user
manual to clean the devices.
To Next Page
Loading...
Need help?
General
