Hasselblad Winder CW - User Manual

Questions and Answers

M
Megan CampbellAug 13, 2025
Why does my Hasselblad Winder CW have temporary incorrect operation?
- R
  Robert DelgadoAug 13, 2025
  Temporary incorrect operation of your Hasselblad Digital Camera can occur due to several reasons. It might be because the batteries have been inserted incorrectly; in this case, check and correctly insert the batteries. Alternatively, the batteries may be exhausted or nearly exhausted, so replace them. Other potential causes include the magazine slide still being in place (remove it), the film being finished (replace the film), or the mode selector being at RC when manual operation is attempted (set the mode selector to the correct position).
B
brian76Aug 16, 2025
What to do if the couplings of Hasselblad Winder CW Digital Camera and winder become ‘out of phase’?
- J
  jonathan79Aug 17, 2025
  To resolve the issue of the couplings of your Hasselblad Digital Camera and winder becoming ‘out of phase’, ensure that the camera is fully wound before fitting the winder. Also, align the red indexes on the winder coupling and bayonet mount.
L
Lisa McdonaldAug 20, 2025
What to do if my Hasselblad Digital Camera is in the unwound status?
- A
  Alicia DouglasAug 20, 2025
  If your Hasselblad Digital Camera is in the unwound status, check that the camera is wound before attaching the winder.
J
Joseph FoxAug 25, 2025
What to do if the winder can neither be attached nor removed from Hasselblad Winder CW Digital Camera?
- C
  contrerasalfredAug 25, 2025
  If the winder can neither be attached nor removed from your Hasselblad Digital Camera, remove the lens first.
J
Joshua FletcherAug 27, 2025
What to do if Hasselblad Winder CW winder operates unusually?
- N
  nicole68Aug 28, 2025
  If the winder on your Hasselblad Digital Camera operates unusually, try resetting the electronics by following the specified procedure.
A
ajonesAug 31, 2025
Why does the IR Remote control have reduction in the working range on my Hasselblad Winder CW?
- B
  Billy VasquezSep 1, 2025
  The working range of the IR Remote control on your Hasselblad Digital Camera may be reduced if the winder is in direct sunlight or other extreme lighting conditions. Use a Release Cord (3044123) instead.
S
Stacey MooreSep 4, 2025
What to do if the Hasselblad Digital Camera winder CW may fail to wind the camera completely?
- J
  James NelsonSep 4, 2025
  If the winder CW on your Hasselblad Digital Camera fails to wind the camera completely, depress and immediately release the winder catch to reset the mechanism.
P
Philip OconnellSep 7, 2025
What to do if Hasselblad Digital Camera has erratic behaviour of winder?
- J
  Jaime PooleSep 8, 2025
  If the winder on your Hasselblad Digital Camera is behaving erratically, check the condition of the magazine or camera for obvious problems. This could be due to winding overload in the magazine or something falling between the release arm and the camera. If this error occurs frequently without any obvious cause, it indicates that the camera, magazine, or winder is in need of service.