English
(O0/O5/10/15/.../9OMIN in increments
of five).
Setting
up the charging
station
NOTICE!
Risk
of damage!
If you do
not set up the charging
station properly, the
charging station,
along with the
hair grooming kit,
may fall over and be damaged
as a
result.
—— Place the
charging station
on a level, dry and non-slip
surface.
1. Connect the device
plug with the
charging station.
2. Insert
the power supply unit
in a socket that is
easily accessible.
3.0peration
CAUTION!
Risk of injury!
Using
the comb attachment
for hair trimmer
attachment
~ The length
of the cut may
vary depending on
the trimming angle.
~
Begin with
a comb attachment
for a longer cutting length and
then use
progressively shorter
cutting lengths
as you progress with the
haircut.
1. Choose
3mm/6mm/9mm/12mm/15mm
comb attachment
that fits
the hair
trimmer attachment.
2. Before
using, please insert
the comb attachment
into the groove on
side of
device according
to below image.
3.
Please always press
the lock of release
button to insert or release the
comb attachment
according to below images.
Changing the
trimmer attachments
WARNING!
Risk of injury!
Switch off
the hair and beard
trimmer, before you
attach or
remove
the
attachments
1. To remove
and change the trimmer
attachments, use your thumbs
to
push
the attachment back
and off the hair trimmer.
2.
To mount an attachment,
run the bottom
clip of the attachment into
the
rail in the hair trimmer.
3. Push the top
part of the attachment
on the hair trimmer until it
audibly
locks into place
and is secure.
4.
Please always press
the lock of release
button to insert or release the
comb attachment
according
to below images.
Changing the
comb attachments
Pushing
on
v To attach
the comb attachments carefully
slide the appropriate comb
attachment over
the hair or
beard trimmer attachment. Press the lower
part of the
comb attachments
firmly until they lock into place.
8
To Next Page
Loading...