Hatteker RFC-588 - Hair Trimmer Operation; Beard Trimmer Operation

English
Removing
~ To
remove the
comb attachments
loosen
the comb attachment
at its
lower end
and pull it
off the hair
and beard trimmer.
- Slide
the comb attachment
for
the beard trimmer
attachment upwards
from
the hair
and beard trimmer.
Hair
trimmer attachment
1. Select
suitable
comb attachment(3mm/9mmrn/6mm/12mm/15mm)
that
fits the hair
trimmer
attachment.
2.
Thoroughly
comb your
hair.
3. Wrap a
cloth or gown
around
your throat and
neck to prevent hair
clippings
from
falling
down your collar.
4. Begin
the haircut
with the
hair trimmer
attachment on the
neck or the
sides
and cut towards
the middle
of the head.
Then cut the front
part of
the
hair towards
the middle
of the head.
5. Hold
the hair trimmer
so that
the comb attachment
is flat on the
head.
Then run it
evenly through
your hair.
6.
If possible,
trim the hair
against the
direction of growth.
7. To ensure
that you
trim all hairs,
run the hair trimmer
over the same
area of
hair several
times.
8. If the
comb attachment
is not
mounted, use
the hair trimmer only
with
the hair trimmer
attachment
for a very
short cut.
9. Comb your
hair thoroughly
again
and again.
Beard
trimmer
attachment
You can use
the Precision
comb (1/2/3/.../9/10mm)
for
the beard
trimmer
attachment.
This adjustable
comb
is only used
for beard trimmer
attachment
(middle size knife
head which
is used for beard).
1. Comb
the beard in
the direction
of growth.
2. Cut
the beard downwards
from
the ear to the
chin. First trim
one and
then the
other side.
3.
Use the beard
trimmer attachment
without
the comb attachment
to
trim
the beard
very short or
the moustache
and contours.
The cutting
edge
of the beard
trimmer attachment
is
pointed towards the
beard at a
right
angle.
4. Push
the comb
attachment so
that the desired
cut length locks
into
place under
the arrow
mark.
S.
Place the comb
attachment
with the rounded
side up against
the bear
and,
from below,
cut
upwards against
the direction of
beard growth.
6. To cut
your moustache,
first comb
it straight down.
Then use either
the beard trimmer
attachment
or
the precision
trimmer attachment.
Start in the
middle above
your mouth;
cut one
side and then the other.
9