Safety 2L41C, 2M41, 2M41Z
16
HATZ
Operator’s Manual
CAUTION
Danger of injury from defective crankhandle.
A damaged or broken handle bar can cause injuries. A worn
cranking shaft can slip out of the starting mechanism when start-
ing and also cause injuries.
▪ Check the crankhandle for a broken handle bar, worn crank-
ing shaft, etc.; replace if necessary.
3.2.3 Machine-specific safety instructions for maintenance work
Introduction
The machine can pose residual risks during maintenance. To eliminate
these risks, all persons working on the machine must follow the general and
machine-specific safety instructions.
Maintenance intervals
▪ Strictly adhere to the maintenance intervals.
Regular maintenance according to the instructions in this Operator's Man-
ual is essential for ensuring reliable operation and the correct engine ex-
haust quality.
▪ Check the safety equipment regularly to ensure it is in good condition and
functioning properly.
▪ Check connections, cables and fasteners regularly to ensure they are in
good condition.
Maintenance work
Maintenance work that goes beyond the scope described in this manual
must only be performed by qualified technicians. We recommend that you
work with one of the over 500 HATZ service stations.
Replacing parts
▪ When replacing defective components, we recommend that you use gen-
uine HATZ original spare parts (see chapter 2 General information, page
6).
▪ When disposing of parts that can no longer be used, do so in accordance
with local environmental regulations or send them to a recycling center.
Measures following maintenance and troubleshooting
▪ Securely reconnect loose electrical connections; check that the electrical
components and equipment are functioning properly.
▪ Check the entire machine for foreign bodies; remove any foreign bodies.
To Next Page
Loading...
