Page 10 of 12
7 Maintenance
The Pack-Vac™ requires little maintenance. The following guidelines will ensure years of service from
your Pack-Vac™
7.1 Cleaning
The Pack-Vac™ tank should be cleaned on a regular basis with mild soap and water to remove mineral
deposits before they degrade the clarity of the plastic. Using water with lower mineral content will delay
mineral build-up. Commercially available plastic polishers and cleaners by Novus can be used. Availa-
ble from www.mcmaster.com
7.2 Gasket installation
o Remove old gasket.
o The lip of the gasket faces out!
o Start at the back center and press the ends together into the groove.
o Next, press each corner into the groove. Do not stretch the gasket.
To Next Page
Loading...