A
B
C
D
E
F
G
H
I
71
2420332270 e10 12 EN
Electric scissor lifts
E
- Driving
For OPTIMUM 6 (OPTIMUM 1530E) and OPTIMUM 8 (OPTIMUM 1930E) only :
The knob ( 1 ) located on the tilt label is used for the autotest.
The autotest mode simulates a slope exceeding the authorized angle. An internal control is
carried out.
• Push on the knob ( 1 ) (less de 1 s) to launch the autotest.
• The 2 LED flicker during the test. The total duration of the test is 5 s.
Messages delivered by the tilt detector
N.B.-:-Once the test carried out, return under normal operation.
3.1.3 - Visual and sound alarms
1. Pull the emergency stop switch- buttons (cut-off) (144, 46).
2. Switch the machine on (72) or (92)(Depending on the machine). All of the ground control
box indicators light up and a sound signal (beep) is emitted.
indicator Status Description
Lit green LED Machine in authorized angular position
Blinkling green LED
Machine exceeding the angular limit within the authorized
time
LED red lit Machine exceeding the authorized angular limit
Green LED and reds lit Fault detector
Green LED and red twinkling Detector in autotest
To Next Page
Loading...
