EasyManua.ls Logo

Haulotte HB40 - User Manual

Haulotte HB40
132 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Maintenance Book
HA18PX
4001022490 E 02.19 USA / GB
Maintenance Book
HA18PX
USA

Table of Contents

Questions and Answers

  • N
    Nicholas WilliamsAug 30, 2025
    How to fix unresponsive platform controls without a buzzer on my Haulotte Construction Equipment?
    • L
      Lindsay RobinsonAug 30, 2025
      If the platform controls are unresponsive without a buzzer, check these potential causes: * Ensure the ground control box selector key is set to the platform control box position. * Verify that the 'Enable Switch' control validation device is enabled and kept pressed down during movement. * Not enough hydraulic oil - top up the oil level.
  • M
    medinasarahNov 8, 2025
    Why won't my Haulotte Construction Equipment engine start or stop?
    • R
      Rhonda StoneNov 9, 2025
      There are several reasons why the engine may fail to start or stop: * The fuel tank might be empty, so fill it. * The batteries could be discharged; recharge them. * Printed circuit fuses in the ground control box might be faulty; replace them. * E-stop push-buttons might be pushed in; pull them out. * The engine may be in restricted mode, indicated by oil pressure, overheating, alternator charging, and clogged air filter indicators; in this case, consult the engine manufacturer's manual or contact HAULOTTE Services®. * The charge indicator bulb could be burnt out; replace it. * The air filter could be clogged; replace the air filter cartridge. * The engine safety relay might be faulty; replace the relay. * There could be poor cable/battery terminal contact; loosen and c...
  • H
    Heidi DonaldsonNov 17, 2025
    What to do if platform controls do not respond on my Haulotte Construction Equipment (buzzer sounding)?
    • J
      John WillisNov 17, 2025
      If the platform controls do not respond and the buzzer is sounding, consider the following: * You might have a platform overload; remove some weight to stay within the authorized limit. * The tilt or slope may exceed the authorized limit; retract the telescope, lower the boom, and correct the tilt. * If there's no high speed, the platform might be extended; lower the boom as far as possible. * If there's no steering, there might not be enough hydraulic oil; top up the oil level. * Ensure the 'Enable Switch' control validation device is enabled and kept pressed down during movement. * If there's no turntable rotation, the turntable rotation locking pin might be inserted in the chassis; remove the pin. * An abnormal noise from the hydraulic pump or pump cavitation indicates no...

Summary

Safety Information

General Safety Rules

Covers essential safety precautions and maintenance implementation.

Hazard Identification and Mitigation

Details risks like uncontrolled movement and electrocution.

Explosion and Fire Hazards

Outlines precautions against fire and explosion risks.

Maintenance and Repair Training

Inspection and Maintenance Schedule

Inspection Program Overview

Outlines the schedule and responsibility for machine inspections.

Daily Inspection Procedures

Describes essential daily checks for safe operation.

Preventive Maintenance Schedule

Details regular maintenance tasks based on hours or time intervals.

Periodic and Major Inspection Guidelines

Specific Maintenance Procedures

Structural Part Inspection (MS0001)

Procedure for inspecting structural integrity, welds, and components.

Wheel Reducer Oil Change (M002)

Pins and Bearing Inspection (MS0002)

Cylinder Inspection (MS0003)

Braking Test Procedure (MS0004)

Describes tests to verify the machine's braking performance.

Slew Ring Lubrication and Tightening (M005)

Wheel Replacement and Torque (M006)

Hydraulic Filter Cartridge Replacement (MS0021)

Troubleshooting and Diagrams

Trouble Shooting Recommendations

Basic checks for common malfunctions.

Troubleshooting Guide

Lists common problems, their causes, and solutions.

Electric Circuit Components Legend

Hydraulic Circuit Solenoid Valves

Electric Diagram Schematics

Provides detailed electrical wiring diagrams for the machine.

Hydraulic Diagram Schematics

Provides detailed hydraulic system diagrams.

Haulotte HB40 Specifications

General IconGeneral
BrandHaulotte
ModelHB40
CategoryBoom Lifts
LanguageEnglish

Related product manuals