To Next PageTo Next PageWhat to do if my Haussmann FSN50 lacks power?
If your Haussmann Nail Gun lacks power, there are several potential causes. First, the tool may be dry and lacking lubrication, in which case you should use air tool oil. Another possibility is that the air pressure is too low, so check your air supply equipment. Finally, the exhaust could be blocked, so try cleaning the exhaust channel.
Why does my Haussmann Nail Gun skip fasteners?
If your Haussmann Nail Gun skips fasteners, it could be due to a few reasons. A damaged pusher spring might be the cause, so consider replacing it. Also, incorrect fastener sizes can lead to this issue, so ensure you're using the correct fasteners. Lastly, a dirty magazine or wear plate can cause problems, so clean the magazine and nose.
What to do if a fastener is jammed in my Haussmann FSN50?
If a fastener is jammed in your Haussmann Nail Gun, several factors could be at play. The driver channel may be worn, suggesting you should replace the wear plate. Alternatively, the driver blade might be broken or worn, indicating a need to replace the driver blade. Finally, bent fasteners can cause jamming, so ensure you are using correct fasteners.
How to fix an air leak in the cylinder cap of a Haussmann FSN50 Nail Gun?
If you notice an air leak in the cylinder cap of your Haussmann Nail Gun, it could be due to loose nose screws. Try tightening them and then re-check for leaks. Another cause might be a cracked or worn gasket. In this case, you should replace the gasket.
Check all parts and accessories are included upon receiving the product. Contact customer service if anything is missing.
Details on nail/staple size, operating pressure, air consumption, capacity, and tool weight.
Instructions for air system setup, including filter, regulator, and automatic oiler.
Requirements for compressed air supply, pressure regulation, and lubrication.
Safety precautions and steps for loading staples into the nailer/stapler.
Steps for loading "L" cleats into the magazine from the side.
Steps to connect the tool to the air supply after setting up the compressor.
Guidance on testing fastener depth, adjusting air pressure, and using the tool.
Procedure to safely disconnect the tool and remove jammed fasteners.
General