HAWEKA BikeBoss User Manual

52 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

BikeBoss

Balancing Stand for Motorbike Wheels

Item No.

825 000 000

002

003

Operating Instructions

(Translation of the Original Operating Instructions)

HAWEKA AG

• Kokenhorststrasse 4 • D-30938 Burgwedel • Tel. +49 5139 8996-0 • Fax +49 5139 8996-222

• www.haweka.com • info@haweka.com

Subject to technical modifications. Reprinting and copies, including extracts, are only permitted with written authorisation

GEB 001 170

Table of Contents

Questions and Answers:

M
Mrs. Shannon TaylorAug 9, 2025
Why is there no indication on the HAWEKA Measuring Instruments display?
- B
  Brendan MorrisonAug 9, 2025
  If there's no display on your HAWEKA Measuring Instruments, it could be due to a few reasons. First, check the power supply unit at the power connection. A defective power connection could also be the cause; try connecting the power supply unit cable into the BikeBoss socket. Lastly, the power supply unit itself might be defective, in which case, you should replace it.
U
ualiAug 22, 2025
What to do if HAWEKA BikeBoss Measuring Instruments shows excessive deviation for repeat measurements?
- S
  Sheila WrightAug 23, 2025
  Excessive deviation in repeat measurements with HAWEKA Measuring Instruments can stem from several factors. Begin by cleaning the bearing shells. If that doesn't resolve the issue, inspect the ball bearings for contamination or difficulty in rotation, and clean the bearing rings if needed. Also, check the clamps for excessive play at the shaft or wheel. Finally, ensure the wheel is firmly clamped onto the shaft, and replace the wheel if it rotates on the shaft.

HAWEKA BikeBoss Specifications

General

Brand	HAWEKA
Model	BikeBoss
Category	Measuring Instruments
Language	English

Summary

General Safety Instructions

Important Safety Instructions

Key safety guidelines for operating the balancing stand.

Product Description

Operating Panel Function Description

Preparation for Mounting the Wheel

Selecting the Correct Mounting Shaft

Guidance on choosing the appropriate shaft based on wheel specifications.

Using Locating Discs and Telescopic Rod

Mounting Wheels with Disc Brakes

Inserting Wheel Shaft Unit

Positioning Shaft in Bearing Blocks

Carrying Out a Measurement

Recording Setting Values

How to measure and record the necessary dimensions for the balancing process.

Entering Setting Values

Inputting the recorded distance and diameter values into the BikeBoss.

Starting the Measurement Process

Initiating the wheel balancing measurement and initial wheel rotation.

Interpreting Measurement Results

Understanding the displayed compensation weights and directions.

Completing Measurement and Removing Wheel

Final steps to remove the wheel after balancing is complete.

Calibrating and Maintenance

Device Calibration Procedure

Calibration: First Measurement Cycle

Calibration: Subsequent Measurement Cycles

Care and Maintenance Guidelines

Troubleshooting

Common System Errors and Solutions

Identifies frequent issues and provides steps for operator-level resolution.

Overview of Motorbike Data

Related product manuals

HAWEKA AXIS 500