PREPARATION
4
1. Check all nuts and bolts are tight before starting.
2. Before Starting the Compressor; remove cover, connect breather pipe
to the oil-hole and attach the air lter.
3. Make sure compressor is in a clean, dry and well ventilated area.
4. Keep voltage within +4% of the rated value.
5. Keep the oil level in the red circle of the oil leveller.
6. For use above 10°C use SAE30 or L-DAB100 compressor oil, For use
below 10°C SAE10 or L-DAB68 compressor oil is recommended.
7. Open the outlet valve, set the pressure switch to the “on” position
and let the compressor run for 10 minutes before attaching any air
tools to ensure all moving parts are well lubricated.
To Next Page
Loading...