10
Warning: After entering into code-learning mode, the previous
remote codes will not be cleared. To clear the previous remote codes (In
case remotes were lost), learn a new remote for at least 4 times, it will
automatically replace all other remotes.
In arm mode if no radio signal bar shown on LCD remote fob then alarm is
out of range of main control box. If on the other hand radio signal bar shown
on LCD remote fob then remote fob is communicating with main alarm unit.
Note: Radio range based on line of sight, unobstructed testing in ideal
conditions. Actual range will vary due to local conditions including but not
limited to environment, terrain, physical obstructions, vehicle location and
orientation interference and other possible impediments.
If battery power is low, remote fob will make “Di..Di..” sound when pressing
any key. This will remind user to change battery. If battery icon start to blink
then battery should be changed immediately, otherwise remote fob will not
function.
Press and button together for 1 second to enter time/alarm adjustment
mode.
Press the button to shift and set among the following icon: time/
min➔time/h➔alarm on/off➔alarm/min➔alarm/h➔quit. The icon will flash
when selected.
Press the button to set each function, press the button to enter next
function setting. When Quit icon flash, press the button and button for
1 second to save and quit. Press the only to quite without saving.
To Next Page
Loading...