EasyManuals Logo

Hawke LRF Series User Manual

Hawke LRF Series
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
DISPLAY ICONS
1. Aim point with horizontal and vertical guides.
2. Distance measurement displayed with 3 digits.
3. Units - “MS” meters, “DEGS” degrees or “YDS” yards.
4. Modes - “BEELINE”, “HIGH”, “∆HIGH” or “ANGLE”.
5. Laser quality - 6 bars or more required for a reading.
6. “LASER” ashes when the laser is in operation.
7. “BATT” displays when the battery power is low.
OPERATION
1. Adjust the diopter setting to get a clear image for your eyesight.
2. When turned on the range nder will start in the same mode it was in when last used.
3. To cycle through the modes simply press the MODE button until you come to the setting you
desire.
4. Simply press the ON button to laze the target you are aiming at.
5. The signal strength is displayed beneath the aim point. A minimum of 6 bars is needed to operate,
10 bars is the maximum strength.
6. The Hawke Laser Range Finder will automatically turn off when not used for 15 seconds.
1
2
3
4
5
76

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hawke LRF Series and is the answer not in the manual?

Hawke LRF Series Specifications

General IconGeneral
Magnification6x
Field of View
Laser TypeClass 1
Accuracy+/- 1m
Battery TypeCR2
Operating Temperature-10°C
Battery Life5000 measurements