Introduction
LED Color Status Description
Lit Power is supplied.
Power Green
Off No Power.
Flash Antenna is transmitting or receiving data.
Wireless
Activity
Green
Off
Antenna is not transmitting or receiving
data.
On A valid link is established.
Flash It is transmitting or receiving data.
LAN
Link/Activity
Green
Off No link is established.
Back Panel
Access Point’s connection ports are located on the back panel. Below is the
description of each connection port.
Ÿ Antenna Connector
This round connection is standard Reverse SMA connector where any
antennas with Reverse SMA connector can connect to the Access Point.
Ÿ DC Adapter Port
Insert the power jack of the power adapter into this port.
Ÿ LAN Port
The Access Point’s LAN port is where you connect to your LAN’s network
devices.
Ÿ Reset
The Reset button allows you to do one of two things.
1) If problems occur with your Access Point, press the reset button with
a pencil tip (for less than 4 seconds) and the Access Point will re-
boot itself, keeping your original configurations.